Download Print this page

Grohe Geneva 24 019 Manual page 4

Hide thumbs Also See for Geneva 24 019:

Advertisement

Application
Operation is possible in conjunction with:
- Pressurized storage heaters
- Thermally controlled instantaneous heaters
- Hydraulically controlled instantaneous heaters
Operation is not possible with:
- Low-pressure storage heaters (displacement water heaters)
Technical data
• Max. flow
• Flow pressure
- min.
- recommended
- greater than 72.5 psi, fit with pressure reducing valves
• Max. operating pressure
• Test pressure
• Temperature
- max. (hot water inlet)
• Water connection
Notes
• Installation of backflow protection must comply with local codes
and regulations.
• Major pressure differences between cold and hot water supply
should be avoided.
1
*18 733
3
English
13 L/min or 3.4 gpm/45 psi
7.25 psi
14.5 - 72.5 psi
145 psi
232 psi
176 °F
cold - Right hand
hot - Left hand
F
A
32mm
C
Installation
See dimensional drawing on page 1.
Flush piping system prior and after installation of faucet
thoroughly!
Side valves, see fig. [1].
• Valve with a groove on the top edge of the cartridge (A) and in
addition marked with COLD should be mounted on the right (cold
water) side.
• Valve without a groove on the top edge of the cartridge (A) and in
addition marked with HOT should be mounted on the left (hot
water) side.
1. Screw the mounting set (B) to the bottom of the thread of the
side valve (C).
Make sure that the rubber washer (B1) is on the top of the fiber
washer (B2).
2. Insert the side valve (C) through the basin hole from below.
3. Place the escutcheon O-ring (D1) on the basin and screw down
the escutcheon (D) until it stops.
4. Screw the cap (E) down to the escutcheon (D).
5. Secure the handle (F) or lever (G) to the stem of the ceramic
cartidge (A).
It is recommended that the lever handle (G) be installed so they
point away from the spout when in the off position.
If the gap between the handle and the cap is excessive, back off
the cap (E) and the escutcheon (D) to minimize the gap.
6. Tighten the mounting set (B) from below to secure the valve.
G
*18 734
E
D
D1
B1
B2
B
HOT
24mm
COLD

Advertisement

loading