Table of Contents
Advertisement
Page 8
RECEIVING AND UNPACKING
The contactor units are subjected to factory
production testing prior to being packed and shipped.
ACCEPTANCE INSPECTION
Confirm that the contactor is complete, correct as
specified and undamaged from shipment and
handling.
Upon receipt of the equipment, do the following:
1.
Make an immediate inspection for damage that
might have occurred during shipment. If damage
is discovered, it should be noted with the carrier
prior to accepting the shipment, if possible.
2.
Carefully unpack the equipment sufficiently to
check for missing parts or concealed damage.
3.
Check for the presence of accessories that are
shipped with the contactor:
-
Contactor wear gauge (Figure 2).
4.
Keep the contactor upright.
Never lay the contactor on its
CAUTION
side or upside down. This
may cause damage.
File a claim with the carrier for any damaged or
missing items and immediately notify the nearest
Toshiba representative.
Do not install or energize
equipment that has been
WARNING
damaged. Damaged
equipment can fail during
operation, resulting in fire and
explosion.
RECEIVING, INSPECTION, AND HANDLING
HANDLING AND MOVING
Care and caution should be used when handling the
contactor to avoid damage to the equipment and
personal injury. Always keep the equipment in a
generally upright position.
Figure 2 - Wear Gauge
Advertisement
Table of Contents
