Inserting /C Onnecting Devices - Toshiba DMF82XKU Owner's Manual

♦ When the AC adaptor is in use, its
temperature may increase. However,
it is not a malfunction. Make sure that
the AC adaptor is disconnected and the
temperature decreases before carrying
it.
NOTE
♦ Do not use the supplied AC adaptor
with any device other than this Digital
Media Frame.
♦ It takes some time when you turn on
the device by pressing the POWER
button (on the side of the Digital Media
Frame) for the fi rst time.
■
To Switch Between Standby
Mode And Power-On Mode
1
Press the POWER button (on the
side of the Digital Media Frame) or the
ON/STANDBY button (on the remote
control) to turn on the device. The
power indicator will turn to green.
2
Press the button again to switch to
the Standby mode. The power indicator
will turn to red.
■
To Power Off
1
Press and hold the POWER button
(on the side of the Digital Media
Frame) for several seconds. The power
indicator goes out.
You can still use the ON/STANDBY
button during the power-off mode.
INSERTING
DEVICES
■
Inserting Memory Card(s)
1
Insert the memory cards in direction
indicated (as illustrated) and slowly
push the cards to lock into place.
■
Removing Memory Card(s)
1
Remove the memory cards slowly
from corresponding slots in direction
indicated (as illustrated).
Power Indicator
(Center)
NOTE
♦ For details about the memory cards
supported, please refer to the section
Specifi cations. (Refer to page 55)
M F O
EDIA RAME VERVIEW
/
CONNECTING
MS
MS
19
MS DUO
MS DUO