Summary of Contents for Decware Z-ROCK
- Page 1 O W N E R S M A N U A L MANUAL NO. 02 REV. DATE: 7/2017 THE Z-ROCK Vacuum Tube EQ/Tone shaper MODEL ZROCK2 Decware High Fidelity Engineering Co., East Peoria IL, USA www.decware.com...
- Page 2 (in some cases up to 10,000 hours). FUSE The fuse is located inside the IEC power cord jack on the back of the Z-ROCK. Use 1.6 Amp fast or slow blow if you live in North America, and use a 1 Amp fuse for countries with 220~240 Volts.
- Page 3 The Z-ROCK has two EQ curves that can be selected via the toggle switch on the rear of the Z-ROCK. Up = EQ setting A and Down = EQ setting B. Both of these EQ settings are fully variable. That is to say that each curve can be adjusted from flat to it’s fully...
- Page 4 This creates a sweet spot in the top half of the green zone shown above where most people will find the best sound. Decware High Fidelity Engineering Co., East Peoria IL, USA www.decware.com...
-
Page 5: Specifications
To assist you in finding the perfect setting for your music, a bypass switch is located on the front of your Z-ROCK that is intended to be used as an A/B switch while you make your adjustments. This way you can hear what it sounds like without the Z-ROCK (bypassed) and then what it sounds like with the Z-ROCK setting you have chosen. -
Page 6: Tube Replacement
This is best accomplished by taking some rubbing alcohol and cleaning the exposed portion of the tube and your thumb and index finger for a good non-slip grip. By doing so the tube comes out easily. Decware High Fidelity Engineering Co., East Peoria IL, USA www.decware.com...