Table of Contents
Advertisement
56
Getting Started
Adding memory (optional)
6
Using a small Phillips screwdriver, loosen the captive screws
that secure the memory module slot cover.
Front of computer
(Sample Illustration) Removing the memory module slot cover
7
Remove the memory module slot cover.
8
Place the screws and the cover in a safe place so that you can
retrieve them later.
9
Carefully remove the new memory module from its antistatic
packaging, without touching its connector.
10
Locate an empty memory module slot on the underside of the
computer.
NOTE
Static electricity can damage the memory module. Before you handle
the module, touch a grounded metal surface to discharge any static
electricity you may have built up.
Avoid touching the connector on the memory module or on the
computer. Grease or dust on the connector may cause memory
access problems.
If no memory slot is available, you must remove a module by
performing steps
2-3
of
"Removing a memory module" on page
59.
Advertisement
Table of Contents
