Directing The Display Output When You Turn On The Computer - Toshiba A2 User Manual

4 Set the display mode by pressing
configuring the Display Properties settings.

Directing the display output when you turn on the computer

Once you have connected an external display device, you can
choose to use the internal display only, the external device
only, or both simultaneously. The quickest way to change the
display output settings is to use the display hot key (
1 Press
2 While holding down
setting you want takes effect.
This hot key cycles through the settings in the following
order:
❖
❖
❖
3 Release the
and simultaneously.
Fn F5
Built-in display only
Built-in display and external monitor simultaneously
External monitor only
key.
Fn
TECHNICAL NOTE: You can also change these settings using
the Display Properties Box.
Set the option for the video controller by clicking Start, then
Control Panel and Display. Choose the Settings tab, click the
Advanced button, select Display Device, select the applicable
Monitor type, and click Apply or OK.
Getting Started
Using external display devices
, press
Fn F5
, or by
Fn + F5
repeatedly until the
77
+ ):
Fn F5