Directing The Display Output When You Turn On The Computer; Adjusting The Quality Of The External Display - Toshiba 3500 Tablet PC User Manual

Directing the display output when you turn on the computer

Once you've connected an external display device, you can
choose to use the internal display only, the external device
only, or both simultaneously. The quickest way to change the
display output settings is to use the display hot key (
1 Press
2 While holding down
setting you want takes effect.
This hot key cycles through the settings in the following
order:
❖
❖
❖
3 Release the
TECHNICAL NOTE: You can also change these settings using the
Display Properties Box.

Adjusting the quality of the external display

To obtain the best picture quality from your external display
device, you may need to adjust the video settings. See the
documentation supplied with the device for additional
configuration steps.
TECHNICAL NOTE: In order to use the simultaneous mode, you
must set the resolution of the internal display panel to match the
resolution of the external display device. The external display
device must support a resolution of 640 X 480 or higher.
Using external display devices
and simultaneously.
Fn F5
Built-in display panel only
Built-in display panel and external monitor
simultaneously
External monitor only
key.
Fn
Expansion Options
, press repeatedly until the
Fn F5
105
+ ):
Fn F5