Advertisement
UNpACKING
Due to modern mass production techniques, it is unlikely that your King Canada cement
mixer is faulty or that a part is missing. If you find anything wrong, do not operate until the
parts have been replaced or the fault has been rectified. Failure to do so could result in
serious personal injury.
Carefully lift all loose parts from the carton and place them on a level work surface.
Assembling Support Stand & Wheels
1. Place the horizontal support (A) Fig.3 into the wheel bracket (B) so that the bolt holes
line up.
2. Secure the support and wheel bracket together using 3 long hex. bolts, washers and
flange hex. nuts. Tighten with a wrench (not included).
3. Place support bracket (C) Fig.3 over the horizontal support (A) so that the bolt holes
line up.
4. Secure them together using 3 long hex. bolts, washers and flange hex. nuts (A) Fig.4.
Tighten with a wrench (not included).
5. Place Stand upright.
6. To install the wheels (D) Fig.3. First slide 2 large washers onto each wheel bracket shafts,
then slide a wheel (B) Fig.5, another washer (C), then insert a cotter pin (D) into the
bracket's axle hole and split the ends. Repeat for the second wheel.
Assembling Lower Drum to Support Stand
1. With assistance, lift the lower drum assembly (A) Fig.5 & 6, insert both supporting arms
(B) into the top of the stand posts (C).
2. Secure the supporting arms to the stand posts using 2 long hex. bolts, washers and
flange hex. nuts (D) Fig.6. Tighten with a wrench (not included).
ASSEMbLY
fIGURE 3
fIGURE 4
fIGURE 5
fIGURE 6
Advertisement
