Toshiba L300-EZ1004X User Manual page 171

2 Double-click the appropriate ExpressCard, which will be listed
under one of the categories shown, for example: Disk drives,
Network adapters, Other, etc.
The operating system displays your ExpressCard's Properties
dialog box, which contains information about your
ExpressCard configuration and status.
The computer stops working (hangs) when you insert an
®
ExpressCard
The problem may be caused by an I/O (input/output) conflict
between the socket and another device in the system. Use Device
Manager to make sure each device has its own I/O base address.
See "Fixing a problem with Device Manager" on page 160
information.
Since all ExpressCards
required to have its own address.
Hot swapping (removing one ExpressCard
another without turning the computer off) fails.
Follow this procedure before you remove an ExpressCard
1 Click the Safely Remove Hardware icon in the System tray.
The Safely Remove Hardware screen appears.
2 Click Safely remove for the device you want to swap.
3 Select the item you wish to remove and click OK.
4 Remove the device when told it is safe to do so.
Never swap modules when the computer is in Hibernation or
Standby mode. This is known as "warm swapping" and is not
supported. For more information on Hibernation and Standby modes
see "Hibernation mode" on page 73
page
The system does not recognize your ExpressCard
Refer to the ExpressCard
Removing a malfunctioning card and reinstalling it can correct
many problems.
Resolving a hardware conflict
.
®
share the same socket, each card is not
74.
®
documentation.
If Something Goes Wrong
®
and "Standby mode" on
171
for more
and inserting
®
:
®
.