Table of Contents
Advertisement
176
If Something Goes Wrong
Resolving a hardware conflict
Nothing happens when you press the keys on the external
keyboard.
You may have plugged the external keyboard in while the computer
was turned on. Using the computer's TouchPad:
1
Click Start, and then click the arrow next to the Lock button in
the lower-right part of the Start menu.
The Shut Down menu appears.
2
Click Restart.
The computer will restart and recognize the device.
Display problems
Here are some typical display problems and their solutions:
The screen is blank.
Display Auto Off may have gone into effect. Press any key to
activate the screen.
You may have activated the instant password feature by pressing
and
Fn
F1
any key, type the password and press
registered, press any key. The screen reactivates and allows you to
continue working.
If you are using the built-in screen, make sure the display priority is
not set for an external monitor. To do this, press
simultaneously (once). If this does not correct the problem, press
and
F5
simultaneously again to return the display priority to its
previous setting.
If you are using an external monitor:
Check that the monitor is turned on.
Check that the monitor's power cord/cable is firmly plugged
into a working power outlet.
Check that the cable connecting the external monitor to the
computer is firmly attached.
Try adjusting the contrast and brightness controls on the
external monitor.
Press
priority is not set for the built-in screen.
simultaneously. If you have registered a password, press
HINT: Holding the Fn key and pressing the F5 key several times will
advance you through the display options.
and
simultaneously to make sure the display
Fn
F5
Enter
. If no password is
and
Fn
F5
Fn
Advertisement
Table of Contents
