Hot-Swap Operation; Parallel Operation - Pewatron Mean Well RCP-1600 Series User Manual

12
RHP-1U
RHP-1U
Figure 3-5 Connection of
3.15 Hot Swap Operation
◎
Built-in "Oring MOSFET", the units can be installed/removed without tuning power off.
◎
Insert units: Grasp the handle and push into the rack shelf through the rail.
◎
Pull out units: Press the clip shown in Figure 3-7 and pull it out.
Caution: Please use adequate force to insert the RCP/RCB-1600 into the rack
on the rear of the units and inside the rack.
3.16

Parallel Operation

3.16.1 Operation of Single Rack Shelf
◎
P arallel operation in a single rack
◎
Each rack shelf (RHP-1U ) has built-in parallel connection/wiring. Once
front end unit are operated in parallel
◎
Please refer to 3.13 & 3.14 for the connection/wiring of other functions
CN2
+V
1
+S
-S
2
-V
Twisted wires
Figure 3-4 Connection of Remote Sense
CN2
3
+V
1
+S
2
-S
4
-V
Local Sense
Figure 3-6 Illustration of how to insert the RCP/RCB-1600 into a rack
Press down
Figure 3-7 Illustration of how to remove the RCP/RCB-1600 from a rack
shelf is only suitable for the identical units (with the same model and the same output voltage/current).
.
RCB-1600-RHP-1U_1610-21407-0001-E-0420
+V
LOAD
-V
shelf . Slamming units into the rack can damage the connectors both
have RCP or RCB units insert
.
"Click"
ed in the rack shelf then t hese
10