Available Components For The Concentric Flue System; Appliance Part List - Bellfires Room Divider Large 3 CF Preparation Manual

6 6 Available components for the concentric flue
system
The gas fire, in combination with the concentric flue system [Ø100 mm - Ø150 mm]
and/or [Ø130 mm - Ø200 mm] (rigid and/or flexible) for the brand types mentioned below,
has been approved in accordance with the European CE-norm for gas appliances and
may therefore be used only with these systems.
Table 1: Approved brands
Manufacturer
Bellfires
Poujoulat
Ontop
Jeremias/STB (STB = Schoorsteen Techniek
Brummen NL)
Jeremias
Modinox
The permitted components for these systems are listed in this chapter. The guarantee on
the appliance lapses if it is installed, fully or partially, with other components or a different
flue system. The concentric flue [Ø100 mm - Ø150 mm] and [Ø130 mm - Ø200 mm]
systems can be used with either a newly-built or existing chimney.
Make sure that the wall or roof termination kit that is used for the installation of the
concentric flue system is also listed in the available parts list.
6.1

Appliance part list

Fig No.
Room divider Large 3
Caution:
Observe the installation instructions that are supplied with the components of
the concentric flue system.
Description
1 Gas fire; Concentric flue connection Ø130/Ø200 mm or Ø100/Ø150 mm.
2 -
3 -
Restriction plate (The different sizes restriction plates are supplied with every appli-
4
ance).
5 Chimney, min. Ø150 mm internal, totally gas tight.
6 Chimney or fireproof sleeving. min. Ø160 mm internal.
7 Ø100 mm internal flexible stainless steel gas vent chimney liner AISI 316TI.
8 Ø150 mm internal flexible stainless steel gas vent chimney liner AISI 316TI.
9 -
Available components for the concentric flue
system
Muelink & Grol system
DUOGAS system
Metaloterm US system
H-Twin system
TWIN-GAS system
PLA system
system
33