Projection Relationships - Panasonic ET-EMW200 Operating Instructions Manual

Projection relationships

The dimensional relationship between the screen and the projector is shown below.
■ Dimensional relationship diagram
Projected image
Note
z This diagram assumes that the size and position of the projected image will be adjusted so
that the image fills the entire screen.
z This illustration is not drawn to scale.
L
LW
LT
L1
SH
H
SW
SD
z Dimension for L1 (approximate values)
Projector
ET-EMW200 ET-EMW300 ET-EMW400 ET-EMW500 ET-EMS600 ET-EMT700 ET-EMT800
model
PT-MZ16K /
PT-MZ13K / 0.125
PT-MZ10K
Note
z The illustrations of projectors in this manual are for informational purposes only and do not
represent a specific projector model. Configurations may vary with the model.
Attention
z To prevent blocking of the intake and exhaust vents, maintain clearances from walls and objects
of at least 1 000 mm (3'3") for the exhaust vent and at least 500 mm (1'8") for the intake vent.
z Avoid setting up in places which are subject to sudden temperature changes, such as near
an air conditioner or lighting equipment (studio lamps, etc.).
6-ENGLISH
SW
Projection distance
Minimum distance
Maximum distance
Lens protrusion dimension
Projected image height
Distance from the lens center to the lower edge of the projected image
Projected image width
Projected image size
0.124
L (LW/LT)
Screen
L (LW/LT)
0.124 0.125
L1
L1
0.117 0.168
(Unit: m)
0.174