Operation - STERWINS 900 JET AUTO-3 Manual

PRESSURE CONTROL UNIT DISPLAY.
• Power On: If lit, the pressure control unit has been powered and is ready for operation. The
pump is not running.
• Failure: If lit, the pressure control has detected a fault.
• Pump On: If lit, the pump is operating. A consumer for discharging transport fluid is open.
• Restart: To restart the pump after resolving a failure, reset the pressure control unit by
pressing this button.
The pressure control unit converts the pump into an automatic domestic water system. The
pressure control unit switch on the pump automatically when water is needed. When the water
supply has been interrupted, the pump will switch off.
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed!
Setting up your pump
• Place the pump on a flat firm surface to ensure safe operation
• Remove the connectors caps
Connecting the intake line
• Screw the standard connector
• Assemble the intake line using a standard connector
assembly is tight enough as a leaking intake line will draw in air instead of water.
• If the water is not so clear, add a filter between the suction connector and intake line.
20151209 SPECIFICATIONS 1300 JET AUTO 5I-3.indd 125
from the connectors &
2 3
onto the suction connector
17
17
125
5. BEFORE FIRST USE

6. OPERATION

, and store them.
5
.
5
and clamp . Make sure the
16
EN
09/12/15 14:41