Network Setup; Connecting To The Network - Sharp AQUOS LC-70LE836E Operation Manual

Network setup

Connecting to the network

To enjoy internet services, you need to connect the
TV to a router with a high speed connection to the
internet. You can also connect the TV to your Home
network server through a router or access point. The
TV connection to the router can either be wired or
wireless.
NOTE
• If you choose a wired connection to the router, you need
an ETHERNET cable (commercially available).
• If you do not have a broadband internet connection,
consult the store where you purchased your TV or ask
your internet service provider or telephone company.
• An Ethernet and wireless connection cannot be used at
the same time. Use only one of the connection types.
• A wireless LAN connection and performance cannot
be guaranteed for all residential environments. In the
following cases, the wireless LAN signal may be poor or
drop, or the connection speed may become slower.
− When used in buildings made with concrete,
reinforced steel, or metal
− When placed near objects that obstruct the signal
− When used with other wireless devices that emit the
same frequency
− When used in the vicinity of microwave ovens and
other devices that emit a magnetic field, electrostatic
charge, or electromagnetic interference
• A stable connection speed is required to play back
streaming content. Use an Ethernet connection if the
wireless LAN speed is unstable.
Wired installation
Use an ETHERNET cable to connect the ETHERNET
terminal on the TV to your broadcast router as
shown below. This is recommended when enjoying
services which require stable connection speeds,
such as streaming media.
E
Wired connection overview

PC

Router (commercially available)

ETHERNET cable (commercially available)

Network
E
How to connect
Router ETHERNET terminal
LAN

ETHERNET cable (commercially available)
Switch on the router (commercially available).
1
Refer to the router's operation manual for
switching on.
Connect the ETHERNET terminal on the TV
2
to the router (commercially available) with an
ETHERNET cable (commercially available).
Go to "Menu" > "Setup" > "View setting" >
3
"Network setup" > "Connection type".
60
Press c/d to select "Wired", and then press
4
;.
Select "OK" to confirm.
5
• If you have failed to connect to the internet in the
above operation, an error message will appear. In
this case, press ATV/DTV/SAT/b to return to the
normal TV screen and check the relevant settings.
• If you want to change the IP settings manually, go
to "Menu" > "Setup" > "View setting" > "Network
setup" > "IP setup" and follow the on-screen
instructions and the operation manual of the router.