Table of Contents
Advertisement
Assembly and Use for the Blender
WARNING: Never leave the appliance unattended while in use.
CAUTION: Handle the blade assemblies with care, as the blades are very sharp.
IMPORTANT: Make sure that the motor base is plugged in for use.
ASSEMBLY
ON
Fig. 1
1
Place the motor base on a clean, dry, level surface.
2
Align and lower the Pitcher onto the motor base.
(Fig. 1) Handle should be aligned slightly to the right of
the "LOCK" symbol on the motor base.
3
Rotate the blender pitcher clockwise until it clicks in
place. As the pitcher rotates, it will lower and the safety
tabs on the bottom of the pitcher will slide under the
safety tabs on the top of the motor base. (Fig. 2)
4
The pitcher can be placed on the motor base two ways;
the handle can be on the front right corner or the front
left corner. (Fig. 3a, Fig. 3b)
5
Holding the blade assembly by the shaft, place it onto
the gear shaft inside the pitcher. (Fig. 4) Ensure that
the blade assembly fits around the gear shaft and that
the blade shaft is standing straight.
NOTE: The blade will fit loosely on the drive gear.
7
1-877-646-5288
ON
Fig. 2
Fig. 3a
Fig. 3b
6
Add the ingredients to the pitcher. Make sure your
total of ingredients don't exceed the highest measured
marking line on the side of the pitcher.
NOTE: When blending any kind of liquids, such as
mixtures of any drinks or smoothies, do not exceed the
"Max liquid" mark (64 oz.) on the pitcher
7
Plug the power cord into the electrical outlet.
IMPORTANT: As a safety feature, the motor will
not work if the pitcher and lid are not installed
correctly. When the pitcher and lid are installed
properly, the ready light will be solid green,
indicating that the blender is ready for use.
Shaft
ON
Fig. 4
Advertisement
Table of Contents
