Advertisement
PRODUCT OVERVIEW
The AC120 is a multi-function compact receiver which can store up to 120
GEMINI, 2-button or 4-button, remote controls. It can be used for control of
alarm systems, remote gate opening, garage door control, etc.
The first 60 remote controls are stored in the
memory (EEPROM)
. Memory can be extended by fitting a second optional
Eeprom (ref. IC0161) to store 60 other remote controls. To insert the second
Eeprom simply
disconnect the module, fit the Eeprom and restore power. The
LED will flash twice to confirm the Eeprom has been recognized.
Eeproms can be fitted indifferently on either socket but the module will not
operate if an Eeprom is only fitted on socket 2.
The socket for the first EEPROM is on the right hand side of the circuit board,
behind the relay (Fig.1).
SOCKET 2 - SOCKET 1
Fig. 1
RELAY
The incorporated relay has NO/NC contacts which can be programmed to
operate in pulse, toggle or pulse with timer mode.
A specific remote control button can be assigned to the relay output.
NB:
To avoid damaging the optional Eeprom during installation, carefully align
notches (see Fig. 2).
ALIGN NOTCHES
SOCKET
Fig. 2
Page 1
microprocessor non-volatile
EEPROM
Ref. IC0161
DIP-SWITCH SETTINGS
1 2 3 4 5 6
Module AC120 is configurable via 6 dip-switches:
ON
N°1-2-3 => operation of relay1
N°4-5-6 => operation of relay 2
OFF
" " indicates that dip-switch setting is indifferent.
-
Fig. 3
OPERATING MODES
Pulse
Toggle state
Timer activation - resettable
Remote control button N°1-2
Remote control button N°1-4
Remote control button N°3-2
Remote control button N°3-4
DIP-SWITCH SET UP
The examples below also apply for setting dip-switches of relay output 2.
DIP 1 OFF, PULSE MODE
=> pressing remote control button will trigger the
relative relay for approx. ½ a second.
DIP 1 ON, DIP 2 OFF, TOGGLE MODE
will change the relative relay state. A subsequent press of the same button
will restore relay initial state.
DIP 1 ON, DIP 2 ON, TIMER
=> pressing remote control button will trigger the
relative relay for approx. 4 minutes. A subsequent press of the same button
will restore relay initial state.
DIP 3 OFF, RC BUTTON ASSOCIATION
position, button 1 is learned (4-button remote control).
DIP 3 ON, RC BUTTON ASSOCIATION
position, button 3 is learned (4-button remote control).
BUTTON 3
BUTTON 1
BUTTON 2
BUTTON 4
Ref. TX7008
Fig. 4
RELAY 1 OUTPUT
RELAY 2 OUTPUT
DIP 1 DIP 2 DIP 3
DIP 4 DIP 5 DIP 6
OFF
-
-
OFF
-
-
ON
OFF
-
ON
OFF
-
-
ON
ON
-
ON
ON
-
-
OFF
-
-
OFF
-
-
OFF
-
-
ON
-
-
-
-
ON
OFF
-
-
ON
-
-
ON
=> pressing remote control button
=> by setting dip-switch in this
=> by setting dip-switch in this
Fig. 6
BUTTON 1:
TEXTURED
BUTTON 2:
SMOOTH
Ref. TX7208E
Page 2
Advertisement
