Getting Started; Using The Pw-E500 For The First Time - Sharp PW-E500A Operation Manual

Getting Started

Using the PW-E500 for the first time

Be sure to perform the following operations before using the PW-E500 for the first
time.
1. Set the battery replacement switch on the bottom
of the unit to the 'REPLACE BATTERY' position.
2. Remove the battery cover.
3. Insert the one battery. Make sure the battery
polarity is correct.
4. Replace the battery cover.
5. Set the battery replacement switch to the
'NORMAL OPERATION' position.
2
6. Open the unit and press o to
turn the power on.
The LCD contrast screen will appear.
• Should a different screen appear,
follow the reset procedure on page
30.
• If the power cannot be turned on:
• Make sure the battery replacement switch is placed at the 'NORMAL
OPERATION' position, then press o again.
• If the power still cannot be switched on, try following steps 1 through 6 in the
above procedure again.
7. Adjust the LCD contrast by using [
], and press e.
The key sound on/off screen will
appear.
8. Select Y or N to turn the key sound
on/off.
The main menu screen will appear.
• The LCD contrast and the key sound
settings can be adjusted later in the
Set-up menu.