Advertisement
Contents
1 x Super Resolution Color Camera with cable pass-through stand
3 x Mounting screws / 1 x Allen key
1x 60ft. BNC/Power Extension Cable
1x BNC to RCA Adaptor
1x Power Adapter
WARNING
- A REGULATED UL/CSA APPROVED power supply is
REQUIRED for use with this camera. Use of a non-regulated, non-conforming
power supply can damage this product and voids the warranty.
Features
• 600TV line resolution for unmatched video quality
• Latest Sony Super HAD™ 2nd generation Image Sensor
• Advanced Noise Reduction for crystal clear Night Vision
• Improved recording storage efficiency by up to 30%
• Dual glass design prevents IR light reflection
• Long range Night Vision for far away night time
coverage
• Weatherproof, vandal resistant aluminum housing*
• Flexible camera design for wall and ceiling mounting
*Not intended for submersion in water. Installation in a sheltered location
recommended.
Installation Tips
• Point the camera where there is the least amount of
obstructions (i.e. tree branches).
• Install the camera in a location that is difficult for
vandals to reach.
• Secure cabling so that it is not exposed or easily cut.
• Connect your system and cameras to a back-up power
supply. This ensures the system continues to record
during power outtages.
Warning / Caution
1.
Read this guide carefully and keep it for future reference.
2.
Follow all instructions for safe use of the product.
3.
Use the camera within given temperature, humidity and voltage levels noted
in Camera Specifications.
4.
Do not disassemble the camera.
5.
Do not point the camera directly towards the sun or a source of intense light.
6.
Use only the supplied regulated power supply. Use of a non-regulated, non-
conforming power supply can damage this product and voids the warranty.
7.
The supplied extension cable is rated for surface mounting only.
Cables for in-wall / floor-to-floor installations are sold separately.
Installing The Camera
- Test all connections and ensure the camera is working
ATTENTION
correctly prior to permanent installation by temporarily connecting the
camera(s) and cable(s) to the viewing/recording solution.
Before Installing The Camera
•
Decide to run the cables through the wall/ceiling (drilling required), or
along the wall/ceiling.
•
If you run the cables along the wall/
ceiling, you must run the cable
through the cable notch on the base.
This will keep the camera base flush
to the wall/ceiling when mounted.
To install the camera:
1. Set the camera in the desired
mounting position and mark
holes for the screws.
2. Drill the holes, then feed the cable through the mounting
surface and mount the camera stand to the desired surface
using the provided screws. Make sure all three screws are
fastened tightly at the connection points.
3. Set the position and angle of the camera using the
provided Allen key.
1
2
2) Loosen the screw and adjust the
1) Twist the ring to tighten / loosen
the stand connection. Adjust the
camera's vertical position.
camera's horizontal position.
Connecting The Camera
To Camera:
Male power connector
Cable notch
BNC Connector
Connect the BNC and
power connectors to the
camera.
BNC to RCA Adapter
DVR/CCTV MONITOR
Video IN
Attach the included BNC to RCA adapter to connect the
extension cable to RCA inputs (i.e. for a TV connection).
Setup Diagram
To Monitor/ DVR:
Female power connector
Connect the BNC connector to
the video input of the monitor/
DVR, and connect the included
power connector to a power
adapter.
TV/VCR
Video IN
BNC to RCA Adapter
Advertisement
