Advertisement
Quick Links
Wiring
Having correctly identified the wiring from your existing
light fitting, fit the cable into the cable clamp and through
Check that...
• You have correctly identified the wires
• The connections are tight
Commissioning
• Attach the mirror to the wall by locating over the
screw heads. Ensure the screw heads are fully
engaged into the hanging slots.
• We recommend cleaning with a soft dry cloth. Do
not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
Live Voltages may be present in this unit even when turned of or when completely disconnected. For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
www.saxbylighting.com
the black rubber grommet. Connect to the connection
block inside the product in the following way:
• No loose strands have been left out of the connection
block.
• The cable clamp is secured over the cable.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
• Activate your new LED mirror by swiping your hand in
front of the sensor.
• Mirror – Use a damp cloth or a propriety glass
cleaner. Do not use abrasive materials as these will
damage the finish.
Iss.1 02072015
Saxby Lighting. BH23 3PE
Instruction leaflet
Merle Mirror
60898
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Saxby Lighting Merle 60898
Summary of Contents for Saxby Lighting Merle 60898
- Page 1 Wiring Instruction leaflet Having correctly identified the wiring from your existing the black rubber grommet. Connect to the connection light fitting, fit the cable into the cable clamp and through block inside the product in the following way: Merle Mirror 60898 Check that... • You have correctly identified the wires • No loose strands have been left out of the connection • The connections are tight block. • The cable clamp is secured over the cable. Commissioning • Attach the mirror to the wall by locating over the • Replace fuse or circuit breaker and switch on. Your screw heads. Ensure the screw heads are fully light is now ready for use.
- Page 2 This product is suitable for use in Zone Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and 2 and outside Zones of a bathroom. satisfactory operation of this product. Please retain these instructions for future reference. See diagram. If this unit is being fitted in a room containing a bath or shower, a 30mA RCD must be used, Warning in accordance with IEE regulations. This is a Class 1 product and must be earthed This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should Please read these instructions carefully before be scrapped. commencing any work. This product is not suitable for dimming. This unit must be fitted by a competent and qualified electrician. This product is rated at IP44. Install in accordance with IEE Wiring regulations and Waste electrical products should not be disposed of current Building Regulations. with household waste. Please recycle where facilities exist. Check with your local authority or retailer for To prevent electrocution switch off at mains supply recycling advice. Installation before installing or maintaining this fitting. Ensure other persons cannot restore the electrical supply Existing fittings must be completely removed before • Using the hole spacing dimensions detailed below, without your knowledge.
Need help?
Do you have a question about the Merle 60898 and is the answer not in the manual?
Questions and answers