Assembly Instruction; Performance - Profi-pumpe JUNG-BRUNNEN Operating Instructions Manual

3. ASSEMBLY INSTRUCTIONS
z Unpack all the water fountain components from
the packaging and lie on a flat surface.
z Connect the pump to the rubber tube. Make sure
the tube is properly connected and is not kinked.
z Connect cable connector to female cord from
pump body.
z Install fountain top on the base, ensure it is stable
before continuing.
z Connect pump cord to adapter.
z Fill clean water to the reservoir.
z Insert the plug into the power socket. If installed
correctly water will start to flow from the feature.
z Mount the solar panel (see illustration). Remove
the protective film from the solar panel (if any) .
z Position the solar panel so that it receives direct
sunlight. The Li-ion battery can only work if the
solar cell is not shaded. Adjust the solar panel
angle to maxinlise the amount of solar energy
collected.
z Connect the pump on the panel (see illustration).
Check whether the flow is fully open (or else
promoted little or no water).
Note: Destilled water is recomended to reduce
mineral deposits and bacteria build-up.
Please note, due to the shape of the slate, some water splashing out of the fountain

4. PERFORMANCE

The perfomance of the pump depends on the orientation of the solar panels toward the sun and the
intensity of. The max. Data obtained under optimal conditions. A feature in the shade or on cloudy
days can not be guaranteed. In models with battery Operation depends on the function of the batte-
ry is charged.
is inevitable in the first few seconds.
4.1 FROST
Frost can cause damage to the garden fountain and pump. If there
is a risk of frost, the garden fountain and the pump must be emptied,
rinsed with clean water and stored in a dry place. Then you will enjoy
it for a very long time!
English 3
Solar panel
Water-
hose
Pump
Summer:
0°- 30°
Spring/Autunm:
30°- 60°