Di-LOG PL280N Instruction Manual
  1. Manuals
  2. Brands
  3. Di-LOG Manuals
  4. Multimeter
  5. PL280N
  6. Instruction manual

Di-LOG PL280N Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Instruction Manual
PL280N
Digital Multimeter
PL280N
EN 61010-1
CAT III 600V

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PL280N and is the answer not in the manual?

Questions and answers

Related Manuals for Di-LOG PL280N

Summary of Contents for Di-LOG PL280N

  • Page 1 Instruction Manual PL280N Digital Multimeter PL280N EN 61010-1 CAT III 600V...

  • Page 2: Safety Notices

    SAFETY NOTICES This manual contains information that must be followed for operating the meter safely and maintaining the meter in a safe operating condition. If this meter is not used in the manner specified, the protection provided may be impaired. Warning! Warns of potential danger, refer to the instruction manual to avoid personal injury or damage to the meter.
  • Page 3 Where applicable use GS38 approved leads (not supplied) these Turn the meter power off when not in use,. Remove the battery if are available from Di-Log. When using test leads keep fingers the meter is in use for a long period. Constantly check the behind the finger guards.

  • Page 4: Controls And Inputs

    CONTROLS AND INPUTS SPECIFICATIONS Function Range Resolution Accuracy LCD Display Function switch DC Voltage 200mV 0.1mV ±(0.5% reading + 2 digits) (V DC) 2000mV 1mV 10A Input Terminal 0.01V COM Input Terminal 200V 0.1V ±(0.8% reading Positive Input Terminal 600V + 2 digits) Data Hold Button AC Voltage 200V...

  • Page 5: Battery Installation

    SPECIFICATIONS Weight 255g Diode Test Test current of 1mA maximum, Size 150mm x 70mm x 48mm open circuit voltage 2.8V DC typical Safety For indoor use and in accordance with Overvoltage Category II, Continuity Check Audible signal will sound if the Pollution Degree 2.

  • Page 6: Back Light Button

    OPERATING INSTRUCTIONS DC VOLTAGE MEASUREMENTS DATA HOLD BUTTON CAUTION: Do not measure DC voltages if a motor on the The Data Hold function allows the meter to "freeze" a circuit is being switched ON or OFF. Large voltage surges may measurement for later reference.

  • Page 7: Dc Current Measurements

    3. For current measurements up to 10A DC, set the function switch CAUTION: Do not measure AC voltages if a motor on the to the 10A range and insert the red test lead banana plug into the circuit is being switched ON or OFF. Large voltage surges may (10A) input terminal.

  • Page 8: Continuity Check

    4. Read the resistance in the display and then set the function 2. Select the 1.5V or 9V BAT position using the function select switch to the lowest W position that is greater than the actual or switch. any anticipated resistance. The display will indicate the proper 3.

  • Page 9: Replacing The Fuses

    24 Month Warranty from any source of voltage before removing the fuse cover. Di-Log instruments are subject to stringent quality 1. Disconnect the test leads from the meter and any item under test. controls. If in the course of normal daily use a fault occurs we will provide a 24 month warranty (only 2.

Table of Contents