After Operation; After Operating Safety; Folding The Handle; Cleaning Under The Machine - Toro 29732 Operator's Manual

After Operation

After Operating Safety

General Safety
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Remove the ignition key before loading the
machine for hauling (electric-start model only).
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.

Folding the Handle

1. Remove the ignition key (electric-start model
only).
2. Loosen the handle knobs until you can move the
handle freely (Figure
Figure 22
1. Handle knob (2)
3. Move the handle forward as shown in
22).
Figure

Cleaning under the Machine

Service Interval: After each use
1. With the engine running on a flat paved surface,
spray a stream of water in front of the right rear
wheel (Figure
The water will splash into the path of the blade,
cleaning out the clippings.
2. When no more clippings come out, stop the
water and move the machine to a dry area.
3. Run the engine for a few minutes to dry the
underside of the machine to prevent it from
rusting.
g032022
22.
14
23).
Figure 23
g002600