Advertisement
5
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color coded sticker on the ink tank to identify
the color of each tank.
Caution:
Be sure to fill each tank with the correct ink color.
6
Carefully seal the bottle using the reverse side of the
bottle tip or screw on the lid for proper disposal.
7
Replace the ink tank cap securely.
8
Repeat the previous steps for the remaining bottles.
9
Close the ink tank cover.
10
Connect the power cord to the back of the product and to
an electrical outlet.
Caution:
Do not connect to your computer yet.
11
Raise the control panel and turn on the product, then
follow steps 12, 13, and 14 to continue ink charging.
Note:
If an error message appears, turn off the product and
check that no protective material has been left inside the product.
Caution:
Do not lower the control panel without first squeezing
the release bar underneath or you may damage the product.
12
To select your language, press
press the OK button.
Note:
You can change the language later using the product's
control panel. For more information, see the online User's Guide.
13
Press and hold the OK button for 3 seconds when the
message to see the setup manual is displayed on the LCD
screen.
14
Press the
button to start charging the ink. Ink charging
takes approximately 20 minutes. Ink charging is complete
when the
power light stops flashing.
Note:
The ink bottles included with the printer are designed
for printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
Caution:
Do not turn off the product or load paper while the
product is charging or you'll waste ink.
3
Load paper
1
Make sure the product is not charging. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
or
to select it, then
3 seconds
20 minutes
Advertisement
