Table of Contents
Advertisement
Truck to Terminal Safety Communications
Batteries
Batteries should always be replaced in a non-hazardous area.
To replace,
1. Remove the T.I.M. cable connector from the programmer.
2. Stretch the rubber sleeve away from the case
(see Figure 2).
3. Slide the battery compartment lid back from the rear
compartment (see gure 3) to remove the old batteries and
replace with new ones. Care should be taken to orient the new
batteries according to the imprinted alignment images in the
compartment. Use 4 standard Alkaline AA batteries.
4. Slide the cover back on the enclosure,
5. Record the serial number off of the back of the unit, and
replace the rubber sleeve by stretching it over the case.
Re-attach the adapter cable.
If unit is not going to be used for an extended period, remove the
batteries to avoid damaging the programmer.
Figure 2. Removing Rubber Sleeve
Figure 3. Removing Battery Cover
Page 3.
Advertisement
Table of Contents
