WaterGeneral RO 585 Installation & Service Manual page 7

STEP 3: MOUNTING THE TANK BALL VALVE
Do not release air from the air valve on the lower side of the storage tank. It is pre-charged at 7 psi at the factory.
put Teflon tape, 6-8 turns
STEP 4: MOUNTING THE DRAIN SADDLE VALVE (don't put in blue area)
The drain saddle valve should fit most standard drain pipe. It
should be installed above the trap and on the horizontal pipe
(1) or vertical pipe (2).
DON'T put on position (3), (4), or blue section
Align the drilled hole in the drain pipe with the drain saddle
using a drill bit or narrow screwdriver
screw on ball valve hand tight, push tubing
through the nut, put tube insert, screw on the
nut
Position the drain saddle in desired location, mark spot. You need
to consider available space for drain tubing
Drill 1/ 4" hole into the drainpipe above the water line of the pipe.
Clean the surface of the pipe.
Pear off the sticky foam pad, then align the center hole around the
drilled pipe hole. Then tape it.
put the complementary piece and clamp them together with the
two bolts. (1) Tighten the two bolts evenly. (2) Connect tubing
7
the tank can be positioned
laying down or standing upright