Features And Specifications Of The Xseries 455 - IBM eServer xSeries 455 Faq

Features and specifications of the xSeries 455

The following table provides a summary of the server features and specifications.
Microprocessor:
™
v Intel Itanium 2 1.3 MHz or higher,
depending on server model
v 3 MB (minimum) Level-3 cache
v 200 MHz front-side bus (FSB), at two
data transfers per cycle, yielding a 400
MHz system bus (minimum)
v Support for up to four microprocessors
™
v XceL4 Server Accelerator Cache: 64
MB
Note: Use the Configuration/Setup Utility
program to determine the type and speed
of the microprocessors in your server.
™
Active Memory :
v Minimum: 1 GB
v Maximum: 56 GB
v Type: 2-way interleaved PC2100, ECC
DDR SDRAM, registered DIMMs only
v Supports 512 MB, 1 GB, and 2 GB dual
inline memory modules (DIMMs)
Drives standard:
DVD/CD-RW: IDE
Expansion bays:
v Two removable media bays (one
DVD/CD-RW preinstalled)
v Supports up to two internal Ultra320
SCSI hard disk drives
™
Active PCI-X expansion slots:
Six 64-bit Active PCI-X expansion slots:
v Two 66 MHz PCI-X slots
v Two 100 MHZ PCI-X slots
v Two 133 MHZ PCI-X slots
Cooling:
Four hot-swap fans
v Two 150 mm x 51 mm fans
v Two 150 mm x 38 mm fans
Acoustical noise emissions:
v Declared sound power, idle: 6.5 bels
v Declared sound power, operating: 6.5
bels
v Bystander sound pressure, idle: 49 dBa
v Bystander sound pressure, operating: 49
dBa
4
xSeries 455 FAQ: Hints and Tips
Power supply:
Two power supplies: 550 watts at
100-127 V ac or 1050 watts at 200-240 V
ac (hot-swappable and redundant at
200-240 V ac only)
Video:
v Integrated ATI RageXL video
v PCI bus interface
v Compatible with SVGA
v 8 MB SDRAM video memory
Size (4 U):
v Height: 17.5 cm (6.9 inches, 4 U)
v Depth: 71.3 cm (28.1 inches)
v Width: 44 cm (17.3 inches)
v Maximum weight: 54.3 kg (120 lb),
depending on your configuration
Integrated functions:
v Broadcom 5704 10/100/1000 dual port
Ethernet controller
v Light path diagnostics
v One external and one internal Ultra320
SCSI port (dual-channel integrated
controller with RAID capabilities)
v Remote Supervisor Adapter (service
processor)
– ASM interconnect (peer-to-peer)
port
– Ethernet port
– Serial port
v IDE controller
v RXE Management Port
v RXE Expansion Ports
v USB ports
v Serial port
v SMP Expansion Ports
®
v Wake on LAN
Environment:
v Air temperature:
– Server on: 10° to 35°C (50.0° to
95.0°F). Altitude: 0 to 914 m
(2998.7 ft)
– Server on: 10° to 32°C (50.0° to
89.6°F). Altitude: 0 to 2133 m
(6998.0 ft)
– Server off: -40° to 60°C
(-104° to 140°F). Maximum altitude:
2133 m (6998.0 ft)
v Humidity:
– Server on: 8% to 80%
– Server off: 5% to 100%
Heat output:
Approximate heat output in British thermal
units (Btu) per hour
v Minimum configuration: 854 Btu (250
watts)
v Maximum configuration: 2646 Btu (775
watts)
Electrical input:
v Sine-wave input (50-60 Hz) required
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v Input kilovolt-amperes (kVA)
approximately:
– Minimum: 0.250 kVA
– Maximum: 1.3 kVA
Notes:
1. Power consumption and heat output
vary depending on the number and
type of optional features installed and
the power-management optional
features in use.
2. These levels were measured in
controlled acoustical environments
according to the procedures specified
by the American National Standards
Institute (ANSI) S12.10 and ISO 7779
and are reported in accordance with
ISO 9296. Actual sound-pressure
levels in a given location might
exceed the average values stated
because of room reflections and other
nearby noise sources. The declared
sound-power levels indicate an upper
limit, below which a large number of
computers will operate.