Samsung HT-DL200 Instruction Manual page 17

Speaker Setup
To set up Speaker Balance
1
Press the Sound Edit button.
•
Each time the button is pressed the selection switches as shown below.
Example: 5.1CH Sound Setup
L C R
LFE
D I G I T A L
LS S RS
Front Speakers: L level, R level
L C R
LFE
D I G I T A L
LS S RS
Rear Speakers: L level, R level
L C R
LFE D I G I T A L
LS S RS
Center Speaker
L C R
LFE D I G I T A L
LS S RS
Rear Speakers
L C R
LFE D I G I T A L
LS S RS
Subwoofer Speaker
The display changes depending on the current audio output
mode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).
31
Sound Edit
2
Use the Left/Right ( / ) button to make
adjustment.
OFF, range of – 6 ~ 0
OFF, range of – 6 ~ 0
range of – 6 ~ – 00 ~ +6
range of – 6 ~ – 00 ~ +6
range of – 6 ~ – 00 ~ +6
Speaker Setting Methods
Press the Test Tone button.
•
The test signal will be sent to the Left Front, Center, Right Front,
Right Rear, Left Rear and Subwoofer in that order.
Test Tone
To End the Language Features Setup
•
Press the Test Tone button again.
While in DSP or PRO LOGIC mode, TEST TONE may
operate differently for VCDs or CDs
Selecting Dolby Pro Logic
Press the Pro Logic button.
Converts Dolby Surround encoded 2-channel sound (e.g., program material received by Stereo
VCR could be Dolby Surround encoded 2-channel material that can be decoded into 4-channel
sound using the Dolby Pro Logic mode). Pro Logic mode can also be enjoyed when in DVD
mode or when playing Dolby Digital or PCM material that are Dolby Surround encoded.
1
Press the Function Selection button to
select the desired function.
•
Select from FM, AM, DVD and AUX 1 IN,
AUX 2 IN.
Test Tone
L C R
LFE
LS RS
Pro Logic
2
Press the PRO LOGIC button.
•
Each time the Pro Logic button is pressed
L R PRO LOGIC
PRO LOGIC : Left, Center, Right, Subwoofer and
Surround Channel
L C R
PRO LOGIC
3-STEREO : Left, Center, Right and Subwoofer
Channel
L R
STEREO : Left, Right and Subwoofer Channel
32