Advertisement
Press the menu
FN and INFO. The menu is in the following order:
1. SET, this is to set the Temperature Sensors.
2. TIME, used to set the Time, Date Month, Year, Weekday.
3. PAR, is to access all the parameters from Fan set up, Zone Qtys, Burner Qtys and
more.
4. FN is to Enable the Zones, Automatically, Manually or via Time settings as well as
Enable the Burners.
5. INFO shows the outside Temperature Sensors and any meters running.
You can access the above by pressing the following steps then Press the Enter key to
access the option required.
1. SET, Used to set the desired temperature for each Sensor probe.
Press
(SET will be displayed), then Press
Probe 1) to change to a desired Sensor Probe Press
Probe,
SP1, SP2, SP3 or SP4. This will depend on how many probes you have connected and
determined by the H5 setting in Parameters. Once you have the desired Sensor Probe Press
then use the
again to set the Temperatures then repeat for SP2, SP3 and SP4 if connected. Once all
Probes are set Press
See section 12 in the manual for more.
followed by the
to change the temperature to the required setting. Press
this will return you to the main menu.
MENU
key to scroll through the menu SET, TIME, PAR,
This will then display SP1 (Sensor
until you find the required Sensor
4
Advertisement
