Installing The Outbound Window - Outbound RA Series Installation Manual

4

Installing the Outbound window

4.1 Preparation of the installation surface and product
• S and the to be glued surface with sandpaper, clean and degrease the surface you want to glue.
• T hen apply activator (or equivalent) according to the instruction of the manufacturer.
• P rimer can be necessary according to the instructions of the manufacturer.
4.2 Installation of the window
• A pply glue to the framework.
• P lace the framework in the opening and apply pressure to the frame.
• U nlock the handle so there is no tension on the frame, do not open the window and leave the
fixation plates in their position.
• M ake sure the frame is completely straight, not bend or twisted in any direction specifically on the
position of the lock.
• C heck visually that all the glue comes out completely under the frame and that the outer frame is
fully in contact with the wall surface without any gabs left.
• R emove excessive glue.
• D o not open the product and do not use clamps to clamp the frame in the wall panel.
• A dhesive tape and foam are allowed.
• L et the glue dry for 24 hours.
• O nce the glue is dry and has sufficient strength, check if the wall panel is still flat and even. A not
flat or not straight wall panel will influence the functioning and closing of the Outbound window and
can result in a product that is not waterproof.
• C heck the window frame on positioning and closing of the window, ventilation position and lock.
Make sure the foam and filling plates are back in position afterwards.
• C lose the window and make sure the wall and window are completely straight and flat, this is es-
pecially important near the lock, if needed use the filling plates to make sure everything is straight.
• F inish the inside seam with glue (or equivalent).
• A fter 24 hours the filling plates and foam can be removed and used and if applicable gas springs
and the blinds can be mounted.
Outbound window and roller blind installation
13