Data Card Replacement; Software Loading; System Setup; Documentation Checks - Garmin GTN 725 Installation Manual

5.9

Data Card Replacement

Handle the data cards carefully. Do not touch the connector edge of the data card.
To replace the data card do the following:
1. Ensure that the GTN is turned off.
2. Remove the data card by pressing the card until it disengages and then pull card to extract from
the unit.
3. With the label facing right, insert the new data card by pushing the card straight into the slot and
press until it is inserted fully.
5.10

Software Loading

5.11

System Setup

5.12

Documentation Checks

5.12.1 Airplane Flight Manual Supplement

Ensure that the Airplane Flight Manual Supplement (AFMS) is completed and inserted in the Airplane
Flight Manual (AFM) or Pilot's Operating Handbook (POH).
1. Fill in the required airplane information in the AFMS.
2. Fill in the appropriate checkbox in the Limitations section of the AFMS corresponding to the
autopilot coupling limitations.
The GPS SELECT setting will determine if the transition into approach mode is
automatic or requires pilot acknowledgement of a message prompt.
3. Fill in the appropriate checkbox in the Normal Procedures section of the AFMS corresponding to
the autopilot mode transitions.
4. Insert the completed AFMS into the AFM or POH.

5.12.2 Instructions for Continued Airworthiness (ICAW)

Ensure that the appropriate aircraft information is filled in on the Instructions for Continued
Airworthiness (ICAW) is completed and inserted in the aircraft permanent records. Fill in the Aircraft
Make, Model, Reg. No. and S/N information on the cover of the ICAW (Garmin document TBD)
Insert the completed ICAW in the aircraft permanent records.
Page 5-34
Rev. A
CAUTION
NOTE
GTN 725/750 TSO Installation Manual
190-01007-02