Advertisement
If the cable pipe is installed outside of the wall
Drill a 21mm-diameter hole on the Wall Mount Adaptor (side and top, respectively).
For your reference, see the figure below.
- The drilling process for the Wall Mount Adaptor must be performed prior to the
fixing process of the Holder Housing according to the steps 4, 5, 6 in this installation
guide.
Put two Rubber Caps upon the Cover Plate.
- Make sure you do this as it is necessary for waterproofing.
6_SADT-103WM
SADT-103WM_ENG.indd 6
* Drilling Points (unit: mm)
(a) Top
COVER PLATE
RUBBER CAP
(b) Side
2008-03-18 오전 9:13:56
Advertisement
