Advertisement
CAUTION
To avoid personal injury:
Park the machine on a firm and level surface.
Apply the parking brake if applicable.
Stop the engine and remove the key from the
machine is applicable.
■
ASSEMBLY PROCEDURE
NOTE:
All assembly procedures listed within this
manual are generally representative of the
machine model for which the manual is
written. Your machine may be configured
differently, but the outline for the procedure
should still be followed. For further support for
any issues not covered within the pages of this
manual, please contact your local Kubota
representative.
1. Remove 2 front right ROPS bolts (M10), and save for
re-use.
2. Install right canopy mount, using ROPS bolts removed
in step 1. Torque to 38 ft.-lbs. (See fig. 2)
3. Repeat on left side.
4. Cut the provided foam tape in half.
5. Install foam tape to the top of the front-to-rear ROPS
tubes on both sides of the vehicle. Foam tape to start
approximately 1-1/2" in front of front ROPS bracket
edge. (See fig. 5) Note: For best adhesion, apply to a
clean, dry surface at room temperature.
PRINTED IN THE USA © KUBOTA TRACTOR CORPORATION 2019
Canopy Mount
(Right)
M10 Vehicle ROPS Bolts
Fig. 2
Foam Tape
1-1/2"
Front ROPS Bracket
Fig. 5
Code: 77700-05183 (Rev. D)
Advertisement
