IBM PS/2 90 XP 486 Hardware Maintenance Reference page 40

7.7 1035 Adapters
Note: When replacing the processor board, be sure to push the levers in
toward the expansion slot until they lock into place.
Cover (1005)
Disconnect any cables necessary for removal.
Note: Before replacing an adapter or processor board, note the slot
location. Install the replacement FRU into the same slot.
Stored configuration information depends on the location of the
adapter. If you must install the replacement adapter in a
different location, run the set configuration program from the hard
disk drive to reset the system-configuration information.
IBM PS/2 Model 90 XP 486 HMR
1035 Adapters
PICTURE 14
¦ Copyright IBM Corp. 1990, 1991
7.7 - 1