11.0 Testing the Ethernet Adapter
To test the Ethernet adapter:
1.
Insert the feature diskette in the diskette drive, then power-on the
system.
The Ethernet Setup/Diagnostic program will automatically
load.
Note:
If the system is already on, type A:F1DIAG at the DOS command
prompt then press Enter to load the Ethernet Setup/Diagnostic
program.
2.
Select Option 2. Test the Adapter from the Main Menu, then press
Enter.
The adapter address will be displayed for a few seconds before
the diagnostics are run.
Subtopics
11.1 RPL Error Conditions for Ethernet
IBM PS/2 Model 25 SX HMR
Testing the Ethernet Adapter
¦ Copyright IBM Corp. 1992
11.0 - 1