Information To The User - Shure ULX-D User Manual

Certifications
ULXD1, ULXD2, ULXD4
Meets essential requirements of the following European Directives:
• WEEE Directive 2002/96/EC, as amended by 2008/34/EC
• RoHS Directive 2011/65/EU
Note: Please follow your regional recycling scheme for batteries and electronic
waste
This product meets the Essential Requirements of all relevant European
directives and is eligible for CE marking.
Hereby, Shure Incorporated declares that the radio equipment is in
compliance with Directive 2014/53/EU. The full text of the EU declaration
of conformity is available at the following inter-net address: http://
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: EMEAsupport@shure.de
ULXD1, ULXD2
Certified under FCC Part 74.
FCC Part 15 and
Certified by IC in Canada under RSS-102 and RSS-210.
IC: 616A-ULXD1 G50, 616A-ULXD1 H50, 616A-ULXD1 J50, 616A-ULXD1
L50; 616A-ULXD2 G50, 616A-ULXD2 H50, 616A-ULXD2 J50, 616A-ULXD2
L50,
616A-ULXD1G50S, 616A-ULXD1H50S, 616A-ULXD1J50AS,
616A-ULXD2G50S, 616A-ULXD2H50S, 616A-ULXD2J50AS.
FCC: DD4ULXD1G50, DD4ULXD1H50, DD4ULXD1J50, DD4ULXD1L50;
DD4ULXD2G50, DD4ULXD2H50, DD4ULXD2J50, DD4ULXD2L50,
DD4ULXD1-G50, DD4ULXD1-H50, DD4ULXD1-J50A, DD4ULXD1-
X52, DD4ULXD2-G50, DD4ULXD2-H50, DD4ULXD2-J50A,
DD4ULXD2-X52.
IC: 616A-ULXD1X52, 616A-ULXD2X52
FCC: DD4ULXD1X52, DD4ULXD2X52
IC: 616A-ULXD1V50, 616A-ULXD2V50
FCC: DD4ULXD1V50, DD4ULXD2V50
Note: For transmitters operating in the V50 and V51 bands: nominal free space an-
tenna gain at middle of the band is typically -6 dBi, and rolls off at the band edges an
additional -4 dB.
ULXD4
Approved under the Declaration of Conformity (DoC) provision of FCC Part 15.
Conforms to electrical safety requirements based on IEC 60065.
10

Information to the user

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device operates on frequencies shared with other devices. Consult the Federal
Communications Commission White Space Database Administration website to de-
termine available channels in your area prior to operation.
No user-operated control of power, frequency, or other parameters are available
beyond those specified in this operating manual.
Canada Warning for Wireless
This device operates on a no-protection, no-interference basis. Should the user
seek to obtain protection from other radio services operating in the same TV bands,
a radio licence is required. For further details, consult Innovation, Science and
Economic Development Canada's document Client Procedures Circular
CPC-2-1-28, Voluntary Licensing of Licence-Exempt Low-Power Radio Apparatus in
the TV Bands.
Ce dispositif fonctionne selon un régime de non-brouillage et de non-protection. Si
l'utilisateur devait chercher à obtenir une certaine protection contre d'autres ser-
vices radio fonctionnant dans les mêmes bandes de télévision, une licence radio
serait requise. Pour en savoir plus, veuillez consulter la Circulaire des procédures
concernant les clients CPC-2-1-28, Délivrance de licences sur une base volontaire
pour les appareils radio de faible puissance exempts de licence et exploités dans
les bandes de télévision d'Innovation, Sciences et Développement économique
Canada.
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada's
licence-exempt RSS(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, in-cluding interference that may cause
undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.