1-3.Primary Specification - NOVO MARK II Original Instructions Manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference whe the equipment is oparated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instraction manual,
may cause harmful interference to radio communications. Oparation of this equipment in
a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.

1-3.Primary specification

・Machine size
width ：635mm
height ：1950mm
depth ：635mm
・power ：220-240VAC 40A 60Hz
・electric consumption ：8.5kw
・weight ：210kg
・operation temperature ：15℃～35℃
・storage and maintenance temperature
・operation humidity
・storage humidity
・install location
・exhaust temperature
・exhaust flow ：2.0 ㎥/min or less
・exhaust pressure loss ：0.5kpa or less
・pollution degree ：2
・overvoltage category ：Ⅱ
・noise level ：less than 73db
Rating-label is at left-side of lower panel.
：-20℃～55℃
：45%～85% RH
：45%～85% RH
：less than 2000 m
：100℃～260℃
5