Trek II UC-1A Manual
  1. Manuals
  2. Brands
  3. Trek II Manuals
  4. Amplifier
  5. UC-1A
  6. Manual

Trek II UC-1A Manual

Universal combo pre-amp
Hide thumbs
1
2

Advertisement

Table of Contents

WARNING!
BEFORE USE, INSPECT ALL TONE CABINET CABLES, CABLE ENDS AND TONE CABINET INPUT
CONNECTORS FOR DETERIORATED INSULATION AND LOOSE OR BROKEN CONNECTORS.
SUCH DEFECTIVE CABLES OR CONNECTORS CAN CAUSE BOTH A SHOCK HAZARD, AND SERIOUS EQUIPMENT
DAMAGE AND MUST BE REPAIRED OR REPLACED BEFORE USING.
WARNING! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE BOTTOM COVER.
NO USER-SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING! FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE ONLY WITH SAME TYPE 8A (OR
LOWER), 250V SLO BLO FUSE. [4A OR LOWER IN 220 / 240V UNITS]
WARNING!
TO AVOID SHOCK HAZARD, UNIT MUST BE CONNECTED TO GROUNDED (3 PRONG) OUTLET OR
PROPERLY GROUNDED ADAPTOR.
WARNING! TO AVOID SHOCK HAZARD, AND SERIOUS EQUIPMENT DAMAGE, DO NOT ATTEMPT TO CONNECT
CABINETS NOT LISTED ON COMPATIBILITY CHART.
®
The Trek II
UC-1A allows most single channel Leslie
virtually any signal source with a standard 1/4" phone jack. Two 1/4" phone jack inputs are provided, one for high level
signals, one for low level signals. Tremolo speed (FAST / SLOW) is controlled by a push switch on the sloping panel. Four
different tone cabinet outlets are provided to interface with the four major Leslie families. These outlets may be used
singularly or in any combination.
TREK II PRODUCTS
TEL: 732-214-9200
UC-1A UNIVERSAL COMBO PRE-AMP

GENERAL INFORMATION

570 JERSEY AVENUE
FAX: 732-214-9257
®
speakers to be driven by portable keyboards, guitars, mixers or
NEW BRUNSWICK, NJ 08901
www.TrekII.com
Rev. 06/06/05 © 1997 Trek II Products
USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UC-1A and is the answer not in the manual?

Questions and answers

Related Manuals for Trek II UC-1A

Summary of Contents for Trek II UC-1A

  • Page 1 ® The Trek II UC-1A allows most single channel Leslie speakers to be driven by portable keyboards, guitars, mixers or virtually any signal source with a standard 1/4" phone jack. Two 1/4" phone jack inputs are provided, one for high level signals, one for low level signals.
  • Page 2 7. Set the controls on the instrument for the loudest expected output. 8. Raise the UC-1A level control until distortion is heard, then back off slightly. If the instrument level is insufficient to do this, move the input cable to the LO LEVEL (high gain) input and repeat Step 8.

Table of Contents