Download Print this page
Sealey LED449 Manual

Sealey LED449 Manual

Aluminium torch 10w cree xpl led adj focus rechargeable usb port

Advertisement

Quick Links

Thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. sAFETy
1.1.
gEnErAl sAFETy
ensure the lamp is fully charged before initial use.
9
Do noT turn the torch on when it is being charged.
8
Do noT shine directly into your, other person's or animal's eyes.
8
Do noT allow children to use the torch.
8
Do noT handle or move the torch whilst it is being charged.
8
Do noT use the torch if you suspect that the battery or the torch casing is damaged.
8
Do noT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
1.2.
ElEcTricAl sAFETy
Use only the USB charging lead supplied to charge the battery.
9
WArning! It is the user's responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
9
An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an
RCd (Residual Current device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an RCCB. You must also read and understand the following instructions concerning electrical safety.
1.2.1.
The electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a
qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.2.2.
The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance
and the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.2.3.
You must ensure that you:
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply.
9
Do noT use if worn or damaged.
8
1.3
bATTEry sAFETy
WArning! To reduce the risk of burns or fire:
Do noT Attempt to open, disassemble, modify or service the battery pack.
8
Do noT Crush, puncture, short external contacts or dispose of in fire or water.
8
Do noT expose to temperatures above 60°C (140°).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
2. inTroDucTion
Single 10W CRee XPl led produces extremely bright, white light with an output of 720 lumens and a working range up to 200 metres. Focus
type can be changed from spotlight to wide area by a twist action of the head. lightweight aluminium housing. Two power options, full power
and 30% energy saving mode. Powered by a rechargeable 3.7V 2Ah li-ion battery. Supplied with micro USB charging lead.
3. sPEciFicATion
model no: . . . . . . . . . . . . . . . . . . . . . . . . . . .lED449
Battery: . . . . . . . . . . . . . . . . . . . . . . . 3.7V-2Ah li-ion
led: . . . . . . . . . . . . . . . . . . . . . . . . . . 10W T6 CRee
lumen output High/low: . . . . . . . . . . . . . 720/210lm
operating Time High/low: . . . . . . . . . . . . . . . .2.5/5hr
Charging Time: . . . . . . . . . . . . . . . . . . . . . . . . . . .4hr
Working Range: . . . . . . . . . . . . . . . . . . . . . . . . . 200m
nett Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.34kg
© Jack Sealey limited
Aluminium Torch 10W crEE XPl lED
ADj Focus rEchArgEAblE usb PorT
lED449
model no:
Original Language Version
led449 | Issue:5 (1,2) 17/05/2019

Advertisement

loading

Summary of Contents for Sealey LED449

  • Page 1 3. sPEciFicATion model no: ......lED449 Battery: ..... . . 3.7V-2Ah li-ion led: .
  • Page 2 Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey ltd’s Batteries Producer Registration number (BPRn) is BPRn00705.