Table of Contents
Advertisement
MN007322A01-B
Chapter 1: General Safety Installation Standards and Guidelines
1.3
Modifications
Any changes and modifications to SLX 5000 that are not expressly approved by Motorola Solutions
may void the authorization to operate the equipment.
1.4
Warnings and Cautions
The following rules must be observed when installing SLX 5000:
•
Only qualified personnel are allowed to install, replace, and service the equipment.
•
Provisioning of SLX 5000 in the Nitro
Installer (CPI).
•
Installation requires special training. The SLX 5000 must be installed only by experienced
installation professionals familiar with local building and safety codes and, wherever applicable,
licensed by the appropriate government regulatory authorities. Failure to do so may void the product
warranty and may expose the end user or the service provider to legal and financial liabilities.
NOTICE: Motorola Solutions and its resellers or distributors are not liable for injury, damage
or violation of regulations associated with the installation of indoor and outdoor units and
associated antennas.
1.5
Important Safety Instructions
RF Energy Exposure and Product Safety Guide for Mobile Two-Way Radios
CAUTION: This radio is restricted to Occupational use only. Before using the radio, read
the RF Energy Exposure and Product Safety Guide for Mobile Radios which contains important
operating instructions for safe usage and RF energy and control for Compliance with applicable
and Regulations. For a list of Motorola Solutions-approved antennas and other accessories,
consult your Motorola Solutions sales representative.
Familiarize yourself with all the following operating and safety instructions before the installation, and
observe them when installing SLX 5000.
•
Keep all product information for future reference.
•
Position the power cord to avoid possible damage.
•
Do not overload circuits.
•
Do not place this product on or near a direct heat source.
•
Avoid placing objects on the terminal.
•
Use only a damp cloth for cleaning.
•
Disconnect the power before cleaning.
•
Do not install the unit near power lines or other electrical power circuits.
•
Keep the socket outlet within easy reach if you need to disconnect the device.
NOTICE: The Certified Professional Installer (CPI) must install this device in accordance
with the National Electric Code (NEC), the National Fire Protection Association (NFPA)
requirements and the local electrical codes. When installed in the final configuration, the
product must comply with the applicable safety standards and regulatory requirements of the
country in which it is installed. If necessary, consult with the appropriate regulatory agencies
and inspection authorities to ensure compliance.
14
™
network must be contracted to a Certified Professional
Advertisement
Table of Contents
