ThingMagic Nomad RFID Setup Manual page 10

RFIDSearchLightInstaller.CAB window
7. After each component is installed, click on the OK button in the upper right of each
window. When the process completes, you must the restart the Nomad.
8. Click on the Start button in the Windows main menu. The Start dropdown menu
displays.
9. Plug the RFID Reader's USB cable into the Nomad.
10. Go to the Before Running the RFID SearchLight
SearchLight application.
Nomad connector panel (bottom of unit)
深圳市铨顺宏科技有限公司
10
The installer installs the following files:

RFIDSearchLightInstaller.CAB

RFIDSearchLight.CAB

FtdiVcpInstaller.CAB

NETCFv35.Messages.EN.wm.CAB

NETCFv35.wm.armv4i.CAB
After each component is installed, you have to press
"OK" in the top-right hand corner to install the next
component.
NOTE: You must restart the Nomad after installation.
Software, before using the RFID
With RFID Reader connected to USB port.
http://www.fuwit.com 咨询热线：400-0581-580
Nomad RFID Reader Setup Guide