HTC One X9 dual sim Quick Manual

HTC One X9 dual sim
___ Inserting your nano SIM and microSD cards
IMPORTANT:
Use a standard nano SIM only.
Don't cut a micro SIM or regular SIM card and insert it into the
nano SIM slot. It's thicker than the standard nano SIM card and
may get stuck in the slot.
Don't disassemble any part of the phone.
Don't try to open the phone or remove the battery by force. This
may damage the phone or its electronics and will invalidate the
warranty.
Don't throw the provided trays away.
You need them to insert your nano SIM cards.
1. With the phone facing
1
down, open the left slot
cover, and then remove the
nano SIM tray from the
SIM 1 slot.
To remove the nano SIM
tray, insert your fingernail
in the small groove in the
tray and then pull the tray
out.
2 2. Place your nano SIM card
into the tray with the gold
contacts facing up and the
cut-off corner facing out.
3. Reinsert the tray, and then
3
close the slot cover. When
reinserting the tray, make
sure the nano SIM card is
facing up so that it doesn't
fall out.
4
4. Open the right slot cover
and do the same steps as
above to insert your second
nano SIM card in the tray
that's in the SIM 2 slot.
Note: You can insert a 4G
LTE or 3G nano SIM card
in either slot. When you
have two cards inserted,
only one card can connect
to the 4G/3G network. The
other card will connect to
the 2G network only. To find
out how to set which card
connects to 4G/3G, see the
user guide.
5
5. Insert your microSD™ card
into the bottom slot, with
the gold contacts facing up
and towards the slot. Slide
the card all the way in until
it clicks into place.
6. To close the right slot cover,
slide the plastic hinge into
the side and press the cover
until it clicks into place.
___ Tips
• To restart your phone when it doesn't respond to touch
screen or button presses, press and hold the POWER and
VOLUME UP buttons for at least 12 seconds. When the
phone restarts, release the buttons.
• Check out our friendly walkthroughs and self-help in
troubleshooting basic problems with the HTC Help app.
, and then find and tap Help.
From the Home screen, tap
Or go to www.htc.com/support/ to find tutorials, the user
guide, and more. Please also read the Safety and regulatory
guide that's included in the box.
© 2016 HTC Corporation. All rights reserved.
HTC, the HTC logo, HTC One, and HTC Sense are trademarks of HTC
Corporation
microSD is a trademark of SD-3C LLC.
All other company, product and service names mentioned herein are
trademarks, registered trademarks or service marks of their respective
owners.
htc.com
HTC One X9 dual sim
___ 插入 Nano SIM 卡和 MicroSD 卡
重要：
只能使用標準的 Nano SIM 卡。
請勿裁剪 Micro SIM 卡或標準 SIM 卡並將其插入 Nano SIM 卡
插槽，因為這些 SIM 卡比標準的 Nano SIM 卡更厚，可能會卡
住插槽。
請勿拆解手機的任何部位。
請勿嘗試強制掀開手機或移除電池，否則手機或其電子零件可
能損壞，而使保固失效。
請勿丟棄隨附的固定座。
您需要這些固定座才能插入 Nano SIM 卡。
1. 將手機螢幕面朝 下 ，打開左
1
側的插槽蓋，然後將 Nano
SIM 卡固定座從 SIM 1 插槽
中取出。
若要取出 Nano SIM 卡固定
座 ， 請 用 指 尖 插 入 固 定 座
上 的 小 凹 槽 ， 然 後 抽 出 固
定座。
2
2. 將 Nano SIM 卡金屬接點部
分 朝 上 ， 截 角 處 朝 向 插 槽
外 ，依此方向放入固定座。
3
3. 裝回固定座，然後關上插槽
蓋。裝回固定座，確定面朝
上 ，以免固定座掉出。
4. 打 開 右 側 的 插 槽 蓋 ， 依 照
4
上 述 的 相 同 步 驟 將 第 二 張
Nano SIM 卡插入 SIM 2 插
槽的固定座。
注意：您可將 4G LT E 或
3G Nano SIM 卡插入任一插
槽。但插入兩張 SIM 卡時
只有一張可連線到 4G/3G
網 路 ， 另 一 張 只 能 連 線 到
2G 網路。如需瞭解如何設
定連線至 4G/3G 的卡片，
請參閱使用指南。
5. 將 MicroSD™ 記憶卡金屬
5
接點部分朝 上 ，插入下方插
槽。往下壓進插槽中，直到
發出喀一聲為止。
6. 若要關上右側的插槽蓋，請
將塑膠轉軸往側邊推入並按
下外蓋，直到其卡入定位。
___
提示
• 如果觸碰螢幕或按下按鈕時手機都沒反應，請重新啟動手
機，按住電源鍵和調高音量鍵至少 12 秒。手機重新啟動
後，放開按鈕。
• 進入 HTC 小幫手應用程式，查看我們簡單易懂的教學步
驟，自行疑難排解基本問題。在主畫面上，點選
找出並點選小幫手。也可以造訪 www.htc.com/support/，
網站上提供了教學課程、使用指南等。亦請詳讀產品包裝
盒內提供的安全與法令注意事項。
© 2016 HTC Corporation.著作權所有，並保留一切權利。
HTC、HTC 標誌、HTC One 和 HTC Sense 均為宏達國際電子股份有限公司
(或稱宏達電) 的商標。
MicroSD 為 SD-3C LLC 的商標。
本手冊中所提及的其他公司、產品和服務名稱為其個別擁有者的商標、註
冊商標或服務標記。
htc.com
，然後