Advertisement
Place the UPS in Standby mode (from Operate mode or
3.
Configure mode) by pressing the Standby button (1).
Unplug the UPS.
4.
WARNING: To reduce the risk of personal
injury from electric shock, avoid operating
the UPS while it is disconnected from the
source of electrical power.
Remove the Serial Port Card located on the rear of the
5.
UPS.
Install the Six Port Card. Be sure to seat it properly.
6.
Connecting the servers
The Six Port Card supports up to three servers on ports 2, 4,
and 6.
IMPORTANT: The number of servers connected must
not exceed the number of load segments on the UPS.
Connect the servers to the load segments on the UPS and
1.
to the ports on the Six Port Card in this configuration.
Port 1 is the configuration port and is used to update the
firmware for the Six Port Card. Ports 3 and 5 are
designated for future use.
Power up the UPS.
2.
Updating the firmware
To update the option card firmware, see the HP website
(http://www.hp.com/go/rackandpower).
Advertisement
