Install The Anti-Tip Bracket; Install Microwave Oven Into Cabinet; Instale El Soporte Antivolcaduras; Instalación Del Horno Microondas - Kenmore 22009 Installation Instruction

Install the Anti-Tip Bracket

1. Draw a line on the cutout floor at the center of the cutout,
and extend the line 1⁄2" down the face of the cabinet.
2. Fold or cut the front edge of the template, along the front
guide line. Place the template flush along the front edge
of the cutout floor, aligning the center line of the template
with the center line of the cutout floor. Mark the centers
of the two screw holes with an awl or center punch for the
anti-tip bracket location as shown.
3. Remove the template and drill two holes for the anti-tip
bracket.
Screws
4. Install the anti-tip bracket onto the cutout floor using two
round-head screws.
Cutout Floor
Anti-Tip Bracket
EN-5

Install Microwave Oven Into Cabinet

1. Carefully return microwave oven to its upright position.
2. Position microwave oven near cutout opening.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug in microwave oven.
4. The bottom bracket must be flat to the cutout floor to
engage correctly with the anti-tip bracket as shown.
Carefully slide the microwave oven back, engaging the
anti-tip bracket. Make sure the power cord is not mashed
or cut as you slide the microwave into place.
Bottom Duct
Anti-Tip
Bracket
Bottom Bracket
5. Center the microwave oven within the cutout opening.
6. Ensure the microwave oven is accurately centered.
Line up the center line on the cabinet with the triangular
hole on the front of the bottom duct.
Screws
7. Drill pilot holes through the positioning flange and then
install five round-head screws at the front of the bottom
duct as shown.
Anti-Tip Assembly
Cutout Opening
Positioning
Flange