Electrical Requirements; Prepare Microwave Oven; Requerimientos Eléctricos; Preparación Del Horno Microondas - Kenmore 22009 Installation Instruction

Electrical Requirements

Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Install according to all local governing codes and ordinances.
Required:
A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event
of an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire for
the electric current. The microwave oven is equipped
with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
WARNING

Prepare Microwave Oven

Attach Bottom Duct
WARNING: To prevent injury, disconnect power at fuse box
or circuit breaker panel to the receptacle into which the
microwave oven is plugged.
1. Unplug the microwave oven before proceeding with the
installation.
2. Remove any loose items inside the microwave oven,
including the turntable and turntable support.
3. Carefully turn the microwave oven upside down.
4. Fit the tab on the bottom bracket into the slot on the back
of the bottom duct, and push down until the bracket is flush
with the bottom of the duct.
Fasten the bottom bracket to the bottom duct by using two
round-head screws.
Rear
Screws
5. Line up the tab on the bottom duct with the slot on the
bottom of the microwave and insert the tab into the slot.
Microwave Oven Upside Down
EN-4
Front
Tab
Screws
Screws
Tab