Advertisement
CLEANING CONTINUED
5a
4
Place the spring and then
Place the Disc onto the
the Burr onto the Shaft. The
Shaft so that the 6 pips*
pointed end of the Burrs
are facing away from the
should face into Grinder
Grinder Body.
Body.
7
8
Attach the Grind Control
Remember to recalibrate
Dial to the Shaft by pressing
and adjust to your desired
it down on the Disc to
setting (See First Use).
expose the thread and
rotating clockwise at the
same time.
*
5b
Align the Ball Bearing on the
Disc with the Recess in the
Burr. Note: You may need
to rotate the shaft to aid
alignment.
12
ADJUSTING THE BEARINGS
If the Shaft starts to become loose, the bearings can be re-tightened:
1
2
Remove the Handle.
Place the Bearing Removal/
Adjustment tool into the
two holes on the top of the
Shaft Release Nut.
4
5
Hold the Handle in position
Should you wish, you can
to prevent it turning
also turn the tool clockwise
and rotate the tool anti-
to unscrew the bearing
clockwise to gently tighten
and shaft, so that they can
the bearing.
be removed for repairs or
cleaning.
Warning: do not over
tighten as this will prevent
the shaft from turning.
3
Carefully Place Handle onto
the Shaft, over the top of
the Bearing Adjustment
Tool.
13
Advertisement
