Weston PRO-SERIES 58914 Manual page 5

Parts and Features
Emulsion Cup: The emulsion cup helps create dressings and sauces that require slowly
adding liquid ingredients into the jar while the blender is in operation.
Lid: The lid is easy to put on, take off, and clean. Always use the lid and the emulsion cup
when the machine is in operation.
Blender Jar: Ounces, cups, and milliliters are clearly marked.
Tamper: The tamper helps mix thick or frozen recipes that cannot be processed with
regular blending. It prevents air pockets from forming and is a handy tool when making
nut butters or frozen desserts.
RESET/OFF (Power) Switch/Circuit Breaker:
The RESET/OFF (Power) Switch is located on the right-hand side of the
blender base. This lighted switch controls power to the blender. This
switch is also a circuit breaker that, if tripped, must be turned off and
back on to reset.
Control Panel
START/STOP Switch:
The START/STOP Switch is used to begin or end the MANUAL mode or
to stop a program before the cycle ends.
PULSE Switch:
Press and hold down the PULSE Switch to blend at the speed setting
shown on the VARIABLE SPEED DIAL in MANUAL mode.
Automatic Overload Protection: This machine is equipped with motor overload
protection. If the motor stops during operation due to overheating, unplug and allow
it to cool down for approximately 15 minutes. Plug machine back in to resume normal
operation.
Variable SPEED Dial:
The center VARIABLE SPEED DIAL
determines the blender speed setting when
blending in MANUAL mode.
Program Buttons:
There are four program settings: SOUP, SMOOTHIE, ICE
CRUSH, and GRAINS. Select the desired program by pressing
the button for that program.
(cont.)
5