FabLab Mendel Quick Start Manual

fablabelpaso.org Ÿ 915.209.2656 Ÿ info@fablabelpaso.org
Mendel 3D Printer

ABOUT

Welcome, new user! Mendel is an open-source Cartesian 3D printer. It is part of
the RepRap line of self-replicating 3D printers. It uses fused deposition modeling
to build up three-dimensional objects by injecting thin layers of melted plastic.

SPECIFICATIONS

Type: Cartesian printer
Repeatability: better than 0.03 mm (30 micron)
Build volume: 200 mm x 200 mm x 160 mm

SAFETY GUIDELINES

1. Please carefully read all the instructions before attempting to operate the
3D printer.
2. NEVER operate or test the 3D printer without proper ventilation in the area
3. NEVER touch the hot end of the printer. It is usually around 200°C and will
cause severe burns.

PRECAUTIONS

1. DO NOT make any modifications to the Mendel or safety features of the
Mendel. Doing so is strictly prohibited.
2. DO NOT attempt to use any other type of filament or print material other
than what is provided or approved by the staff.
3. DO NOT place hand or any other body part in the print area.
4. AVOID breathing near the hot end where the plastic is being melted.
806 Montana Ave. El Paso, TX 79902