Gait up GO Quick Start Manual page 6

Get started with GaitUp GO – Normal use (2/ 2)
7 The Physilog6 will connect automatically after
selecting the test if it has previously been
linked to the mobile application.
Follow carefully the instructions that appear
on the mobile application screen. The location
of the sensor device vary depending on the
test to be performed. Follow the instructions
shown on the screen and tap "Ready"
9
Stop the test: some tests stop automatically
after performing the movement. If the test is
not listed below, tap "End" to stop the test.
NOTE: If the test did not stop automatically,
tap "End".
Test type
Monopodal balance comparison
One leg balance
Balance on two legs
Semi-tandem balance
Romberg test
Sit to stand transfer
Vertical jump 1 leg
Vertical jump 2 legs
2 minutes walking test
Timed Up and Go
Timed Up and Go in dual task
© 2020 Mindmaze SA & Gait Up SA. All Rights Reserved. MindMaze, Gait Up, Gait Up GO the Mindmaze LOGO, the Gait Up LOGO and Physilog are trademarks or registered
trademarks of Mindmaze Holding SA.
Stop automatically after:
30 seconds (x 2)
30 seconds
30 seconds
30 seconds
30 seconds (x 2)
5 sit to stand detected
1 jump detected (x 2)
3 jumps detected
2 minutes
1 Timed Up and Go detected
1 Timed Up and Go detected
8
Start the test
instructions on the mobile application.
10
At the end of the test, save or discard the
result of the previous test.
A confirmation request appears to use
one credit to generate the report
NOTE: If the "Direct access to the
results" is not activated the results will
be automatically saved in the phone and
the report can be generated later.
by following the