Hyundai HC 910 Instruction Manual page 22

– Do not put the trimmer on hot heat sources (e. g. oven, stove, radiator, etc.).
– Also, do not put the trimmer in the on position on soft surfaces (e. g. bed,
towels, sheets, carpet); the surfaces or the appliance could get damaged.
– Do not use the appliance while having a bath, having a shower or taking a sauna
and for trimming wet or artificial hair.
– Oil: Warning, Avoid contact with eyes, Do not drink! Keep the special oil bundled
with the device out of reach of children, persons insane. Heed the instructions
written on the package when handling!
– Never put the power cord on hot surfaces and never let it hang over table edge
or worktop edge. If the cord is caught or pulled, e.g. by children, the appliance
may overturn and fall down, causing a serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire,
it must not be sunk into water or bent over sharp edges.
– Only use this appliance for the purpose it was designed for, as specified in this
manual. Never use the appliance for any other purpose.
– The producer is not responsible for any loss caused by improper handling of the
appliance and its accessories (e. g. injury, appliance damage, fire, etc.) and its
guarantee for the appliance does not apply in the case of non–compliance with
the safety instructions above.
II. DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (fig. 1)
A – trimmer
A1 – ON/OFF switch
A2 – haircut length lever
B – attachments
B1 – hair length approx. 3 mm
B2 – hair length approx. 6 mm
C – accessory
C1 – brush
III. INSTRUCTIONS FOR USE
We recommend oiling the blades with the oil attached. You may use the appliance
without attachment – for trimming contours or with a selected attachment B
according to a desired hairstyle length. Put the attachment on the head of the
appliance, so that it locks in place. Proceed reversely when taking the attachments
off. Wash, dry and brush your hair with a brush before trimming. Turn the
appliance on with the switch A1 (position „I"). Hold the appliance with ease so that
you can control it perfectly. Trim off only little bits of hair first to get used to the
length of hair which the attachment offers. For an even haircut never go through
the hair fast. The clippers work best at their own pace. Turn the clippers off with
the switch A1 after finishing (position „0").
A3 – cutting blades
A4 – supply cord
B3 – hair length approx. 9 mm
B4 – hair length approx. 13 mm
C2 – oil
22 / 30